DynaColor QIG-510 Series Guia de Instalação descarregar pdf (Página 29)

Installation Guide

STEP 1

Fasten the Fixing Plate on the

Dome Camera’s back plate by

first inserting the side with three

holes into its mate slot on the

camera’s back plate. Push the

plate inside the slot to the left,

aligning the three holes on the

Fixing Plate to the ones on the

back plate, and then screw the

Fixing Plate tightly using the

supplied M3 screw.

NOTE: The orientation of

the Fixing Plate is shown

in the figure on the right side.

STEP 2

Remove the Decoration Ring

from the Hard Ceiling Mount.

STEP 3

Place the Hard Ceiling Mount to the desired position on the ceiling,

and mark the position of the three screw holes.

STEP 4

Drill these holes on the hard ceiling.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 58 59

Sem comentários

DynaColor QIG-510 Series Guia de Instalação Página 29