DynaColor QIG-510 Series Guia de Instalação descarregar pdf (Página 13)

Installation Guide

3.1.3 ID Setup

Please change the analog Dome Camera’s ID if there is more than one Dome

Camera in the same network. Use the switch to change your Speed Dome

Camera’s ID by setting the 10-bit dip switch. For instance, if the camera’s ID

is 006, set the SW 8 and SW 9 to “ON,” with the rest to “OFF,” as shown

below.

For switch configuration details, please refer to Appendix B: Switch Settings

Index Table in the Dome Camera’s User Manual.

NOTE: No two Dome Cameras should be given the same ID, or

communication conflict may occur.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 58 59

Sem comentários

DynaColor QIG-510 Series Guia de Instalação Página 13